Probe C (HV10) is designed for rough surfaces and is purchased separately.
The design of hardness testers TQ-4C provides full interchangeability of probes!
Probe C (HV10) is purposed for hardness measurement of following:
- Carbonaceous and structural steels;
- Items with surface-hardened layers such as cementation, nitride hardening, high frequency current hardening;
- Heat-proof, corrosion-proof, non-corrosive steels;
- Items of complicated configuration;
- Products with rough, poorly prepared surface;
- Thick-walled, large-sized objects.
Advantages
- Stable readings independent from force and time of pressing.
- Easy measuring in hard-to-reach areas.
- Ultra-small control area (from 1 mm).
- Control in slots and blind holes from 5 mm (not provided by rival devices).
- Invisible print on mirror-surface.
- Low sensitivity to the curvative of surface, thickness and weight of product.
Probes characteristics
Photo |
Probe Type/Load |
Weight/thickness/ surface roughness of the article under check |
Length/ Diameter
|
Application |
|
«А» 50H/5 kg |
1 kg/3 mm/Ra 1,6 |
145/26 mm |
Solving of main hardness testing tasks |
«H» 10H/1 kg |
1 kg/2 mm/Ra 0,8 |
145/26 mm |
Hardness testing of electroplated coating (chrome, copper, nickel, zinc, tin), thinwalled and small-sized items |
«С» 100H/10 kg |
1 kg/4 mm/Ra 3,2 |
145/26 mm |
Hardness testing of items with unprepared surface, large items and heavy-duty equipment |
|
«К» 50H/5 kg |
1 kg/3 mm/Ra 1,6 |
76/33 mm |
Hardness testing of inner surface of tubes, tanks and other hard-to-reach areas |
|
«AL» 50H/5 kg |
1 kg/3 mm/Ra 1,6 |
194/26 mm |
Hardness testing in hard-to-reach areas as pinholes, grooves, in-between gear teeth zones (length of tip 65 mm) |
ATTENTION! There is a built-in Lemo plug-in in the probe. Connection cable is sold separately.
Probe C (HV10) is designed to control the hardness of products with rough surface; thick-walled and large objects.
Requirements to controlled item:
- Items heavier than 1 kg and thicker than 4 mm need no additional preparation;
- Items lighter than 1 kg should be fixed in a vice clamp or on a support plate by fixing paste;
- Items with a thickness of less than 4 mm should be fixed in a vice clamp or on a support plate by fi xing paste;
- Roughness of controlled surface providing best measurement accuracy is 3.2 RA.
ATTENTION! There is a built-in Lemo plug-in in the probe. Connection cable is sold separately.
Photo |
Probe Type/Load |
Length/Diameter |
Weight |
Application |
|
«C» 100 H (10 kg) |
145 / 26 mm |
0,3 kg |
Hardness testing of items with unprepared surface, large items and heavy-duty equipment |
ATTENTION! There is a built-in Lemo plug-in in the probe. Connection cable is sold separately.
Probe C (HV10) — 1 piece
ATTENTION! There is a built-in Lemo plug-in in the probe. Connection cable is sold separately.