Home / Additional equipment / For Crack depth meters / Standard probe “1x4” for Crack depth meter ET-28
- Description
- Exploitation
- Technical specifications
- Delivery set
Sensor «1×4» included in the standard delivery of Crack depth meter ET-28 electro potential.
Sensor is designed to measure the depth of cracks from 0.5 to 30 mm. This sensor has 4 electrodes, which are arranged in a row.
Operational advantages
- Control of ferromagnetic and non-ferromagnetic materials(stainless steel, aluminum alloys, etc.)
- Measurings range – from 0.5 to 30 mm.
- Mobile spring-loaded contact electrodes of the sensor enable the user to perform measurements on curved surfaces.
- Low impact of the material electromagnetic properties on the measurement result.
Crack depth meter ET-28 – high-precision instrument for measuring the depth of cracks exposed on various metals and alloys (incl. stainless steel, duraluminum), previously detected by other methods.
The operating principle of the Crack Depth Meter – AC electro potential measuring that provides prompt and precise depth test (in comparison to traditional methods).
Typical control objects:
- Shafts, rolls, rolling mills, details of constructions, machines and mechanisms;
- Pipes, tubes, oil-and-gas pipelines;
- Pressure vessels;
- Energy industry devices.
ATTENTION! If you buy only Sensor «1×4», the Crack depth meter ET-28 should be sent to the retrofit and alignment.
Before each use of the device for measuring the depth of cracks on the product, it is necessary to check its operation on a control sample.
Stages of crack depth measuring
- Setting of the “0” – measuring on fl awless location of the object.
- Measuring of crack depth – contact electrodes are located on the opposite sides of the crack, measurement result in mm is shown on the screen.
Requirements for control objects
- Surface roughness – below or equal to 40 Rz (10 Ra).
- Stable electric contact with the sensor electrodes.
ATTENTION! If you buy only Sensor «1×4», the Crack depth meter ET-28 should be sent to the retrofit and alignment.
Sensor «1×4» is designed to measure the depth of cracks from 0.5 to 30 mm.
This sensor has 4 electrodes, which are arranged in a row.
ATTENTION! If you buy only Sensor «1×4», the Crack depth meter ET-28 should be sent to the retrofit and alignment.
Sensor 1×4 (4 electrodes in one row) — 1 piece
ATTENTION! If you buy only Sensor «1×4», the Crack depth meter ET-28 should be sent to the retrofit and alignment.