Probe E is a replaceable probe for Leeb Hardness tester TQ-3C.
Probe with indenter made of polycrystalline of boron nitride intended for control of materials with high hardness.
The Probe E is used for hardness testing:
- All basic types of metals and alloys without additional calibrations (structural, tool, corrosion-proof, heat-proof, non-corrosive steels and alloys as well as alloys of nonferrous metals, castiron, aluminium, bronze, brass).
- Items with surface hardening and high frequency current hardening.
- Items of complicated configuration.
- Heavy and big items with rough surface.
Advantages of Leeb probe
- Hardness measurement in hard-to-reach areas.
- The spatial position of the probe does not affect the measurement result.
- The robust housing is not subject to mechanical stress.
- Long service life.
Probes characteristics
Photo |
Probe Type |
Weight/thickness/ surface roughness of the article under check |
Length/ Diameter
|
Application |
![](/images_t/55dccc12a841913bace01fb349ed5353.webp) |
«D» |
3 kg/6 mm/Ra 3,2 |
138/21 mm |
Solving of main hardness testing tasks with surface roughness less than 3.2 Ra |
«E» |
3 kg/6 mm/Ra 3,2 |
138/21 mm |
Probe with polycrystalline indenter made of cubic boron nitride to test materials with high hardness
|
![](/images_t/9c1c82d702d97e1e8bb87eb6158628c6.webp) |
«G» |
6 kg/55 mm/Ra 7,6 |
200/29 mm |
Hardness testing of high structure inhomogeneity items with surface roughness more than 7.2 Ra |
ATTENTION! If you buy only Probe E, the Hardness tester TQ-3C should be sent to the retrofit and alignment.
Probe E with indenter made of polycrystalline of boron nitride intended for control of materials with high hardness.
Requirements to controlled item:
- Items heavier than 3 kg and thicker than 6 mm need no additional preparation;
- Items with a thickness of less than 6 mm should be fixed in a vice clamp or on a support plate by fi xing paste.
- Roughness of controlled surface providing best measurement accuracy is 3.2 RA.
ATTENTION! If you buy only Probe E, the Hardness tester TQ-3C should be sent to the retrofit and alignment.
Photo |
Probe Type |
Length/Diameter |
Weight |
Application |
![](/images_t/12987ad2c4518e55cdcf3393025ba5c5.webp) |
«E» |
138/21 mm |
0,3 kg |
Probe with indenter made of polycrystalline of boron nitride intended for control of materials with high hardness |
ATTENTION! If you buy only Probe E , the Hardness tester TQ-3C should be sent to the retrofit and alignment.
Probe E — 1 piece
ATTENTION! If you buy only Probe E, the Hardness tester TQ-3C should be sent to the retrofit and alignment.